Please note the following amended information regarding wiring connections, as shown on pages 9 and 13 of this manual.

Please refer to Wiring Diagram 7. for reference.

In most instances the mover units should be installed in front of the axle as per the diagram with the wiring sequence as follows:

Motor A positive (+) to Control Unit Terminal 1

Motor A negative (-) to Control Unit Terminal 2

Motor B positive (+) to Control Unit Terminal 3

Motor B negative (-) to Control Unit Terminal 4


If it is necessary to fit the mover to the rear of the axle please follow the following wiring sequence:


Motor A positive (+) to Control Unit Terminal 4

Motor A negative (-) to Control Unit Terminal 3

Motor B positive (+) to Control Unit Terminal 2

Motor B negative (-) to Control Unit Terminal 1